Contact Us Todayo: 405.288.0233f: 405.288.0238
Item ID
Three Heat / Two Cool, Manual / Auto Changeover Programmable (7 Day) Digital Non-Communicating Thermostat - With Humidity Control, 18 to 30 VAC, 50/60 Hz Input Power, Fault LED, Use 04 with ClimaDry Units
Item Desc
Dehumidification Set Point Range
15% to 95% RH
6.25" L x 4.25" W x 1.1" D
Electrical Rating
18 to 30 VAC, 50/60 Hz
Humidification Set Point Range
10% to 45% RH
Operating Conditions
32°F to 104°F, 10% to 95% non-condensing
Output Ratings
Maximum current for each output is 1.0 Amp (2.0 max. output total)
Set Point Range
40°F to 90°F
Client Number
• 7-day programming • Dehumidification output is designed to work with Whole House Dehumidification Modulating Reheat option or with ECM fan motor dehumidification mode • Integrated control of both temperature and relative humidity • Integrated control eliminates separate thermostat and dehumidistat/humidistat • Thermostat can be programmed to use humidification output to control a humidifier • Selectable differential or proportional integral operation • Four periods per day • ºF or ºC temperature display • 12 or 24 hour clock • Individual heat and cool set points • Zero temperature droop performance • Automatic (program mode) or manual (HOLD) operation • Convenient overrides allow temporary set point changes • Set points are permanently held in memory (no batteries used) and retained during power outages • Room temperature off set adjustment • Progressive Recovery anticipates the time required to bring the space temperature to the next programmed event, and brings on the heat pump accordingly • Large backlit dot matrix display is activated whenever a key is pressed and remains on for 25 seconds • Menu-driven programming with five navigation buttons (up/down/left/right/select) for ease of use • Fault indication with red backlight display • Configurable service interval messages and servicing contractor contact information • Keypad lockout • Back-plate wiring connections for easy installation • Exclusive fault identification (When used with CXM or DXM) displays fault from CXM/DXM board (e.g. condensate overflow) and suggests possible causes • Compatible with AST008 sensor for use as remote and/or outdoor sensor • Dual fuel capable Application: • The ATP32U04 Thermostat provides 3 stages heating, 2 stages of cooling, and programmable temperature/humidity control of 24V water-source heat pump equipment